Punching Printing Knowledge
Punching


File holes on a continuous form are punched on a web press as the forms are printed.

Note: The carbon in a carbon interleaved continuous form will not be punched.

 

  • Standard configurations are:
         - two holes, 2 3/4" center to center, top or bottom of the form.
         - three holes, 4 1/4" center to center on the left side of the form
  • Configurations other than standard may have restrictions so consult your supplier.
Punching Specifications

              Width 9 1/2"

     Width 9 1/2"

               Running parallel
               to depth

Running parallel
to width

Specifications needed by your supplier:

Number of holes - Diameter size of hole - Center to center measurement from hole to hole - Location
Example: 3 holes - 1/4" diameter - 4 1/4" center to center - at left
Also indicate if the holes are parallel to the depth or parallel to the width.

 


Back to Top

More Continuous Products >>

Additional search results for:
   Punching
knowledge
Punching
Punching
Punching
Punching
Punching
Punching
Punching
glossary
Marginal Punching
File Hole Punching
Bindery Punching
Search
Enter keywords to search
PrintingTips.Com Knowledge
Print Preparation
Print Products
Continuous Products
Size
Design Features
Paper
Ink
Fastening
Perforations
Punching
Numbering
Labels
PS Tape
Storage
Direct Mail
Envelopes
Integrated and Affixed
Labels
Laser Sheets
Mailers
Single Sheet Products
Unit Sets
RelatedContent
knowledge
glossary
Features of Interest
Featured Ad
Terms of Use |  Privacy Policy |  Site Map |  Index |  Contact Us
Reproduction in whole or in part without written permission is strictly prohibited.
© Copyright 2024 Tecstra Systems, All Rights Reserved, PrintingTips.Com

Punching - PrintingTips.com

Printing Tips Home Customer Service Knowledge Glossary Printing Tips Home